Recent content by haVOC1787

also is there a way to turn off the auto hold breath on the quick scope settings?

I noticed on the quick scope settings the only parameter to set is when the bullet is fired. The scope is set to zoom in a little too much for optimal quick scope. Can you please reduce the amount zoom in or just allow it to have a zoom in timmer setting?

here are the best quick scope delay I have found with the msr quickdraw 32 34 36 38 40. 34-36 works the best for me. I was wondering if it was possible to update the quickscope button to the r1 button? THanks

When I bought mine a few years back they were $29.99 Then i think you had to go up on them because increase in how much to produce them.

I have 2 new chips and 1 in a controller that still works but the y button has about went out. I will sell them all as a package or separately if thats aloud or anyone wants the old style chip.

http://modspace.com.au/shop/index.php?m ... 44c15dd982 They show to still sell the old viking chip. for anyone who is interested

for the most part I would think its a duo. I could see using the dpad or the back button by the xbox button. Its very rarely used in any games.

forgot to post link http://forums.xbox-scene.com/index.php?showtopic=660109

well I have found a topic on xboxscene about wired controllers. One is a matrix type and the other is a new CL (common line). I am going to go buy one tonight and wire it up and see what I can come up with. I know the voltage readings are backwards in the matrix versus cg. If you were to take...

yes i knew about the npn transister. It is needed and can be bought at radioshack. Consolecustoms.net has an 8pin 12f683 chip it uses in the ps3 controllers but there are like 4 different models of boards. Check consoles website and look at their tutorials. It can be done with very few resistors...

Does the matrix controllers mimic that of wired controllers? or do wired controllers act as cg1,cg2 boards? I am interested in helping with this if odingalt needs/ wants it. I can write some code but prefer not to. But i can test solder points, resistors, effectiveness and programing glitches as...

I have an older chips from viking from a controller that died. If you can give me the resister sizes and solder points on the controller I will see about making one and testing it.

I would love to see this done. I would rather have this then a perfect reload for lancer.

I have bought like 5 controllers looking for the new board. No luck yet dam gamestop having old shit. When I find the controller I will post trace points ect.

Yes as far as that goes I bought some 2450mah duracell recharge batts and a pack of the 2700. They last for a good week playing 4-6 hours a day most days. I found a sell target was having on them. the charger and 4 batts were $10 instead of norm 22.99.