Search results

  1. R

    XB1 3DS controller.

    Just for the record on the miniM4pper chip, you can remap all 8 buttons to one Tact if you wanted, not just up to three at once, though I'd have no idea why anyone would want to. It's a bit late to mention this now, but that thing makes for a much, much cleaner install if it's mounted on the...
  2. R

    XB1 Controller PCB Scans and Traces

    PnC BOARD TOP PnC BOARD BOTTOM PnC BOARD TOP CLEAN PnC BOARD BOTTOM CLEAN
  3. R

    XB1 Controller PCB Scans and Traces

    PLAY & CHARGE PACK The PnC battery pack this time around is a 3v Lipo, 1400mAH, 4.2Wh. The actual cell is 3.7v and 2.33Wh, so where does the 4.2Wh come from..? ..from the other 2.33Wh cell in there that is in parallel with the first one. The PnC pack uses the same contacts as the AA...
  4. R

    XB1 Controller PCB Scans and Traces

    Welcome. First post updated with a little more info, still plenty to go.
  5. R

    XB1 Controller PCB Scans and Traces

    Clean PCB Scans. BUTTON/POWER BOARD TOP CLEAN BUTTON/POWER BOARD BOTTOM CLEAN MCU BOARD TOP CLEAN MCU BOARD BOTTOM CLEAN
  6. R

    XB1 Controller PCB Scans and Traces

    XB1 Controller PCB Scans, Traces and Info The new XB1 controller is a CG (Common Ground) setup for all of the Buttons. The Triggers are also in a setup where they go Lo when pressed, but they are a bit more complex than the 10k Potentiometer style that its 360 predecessor sported, more detail...
  7. R

    Chip Swap 360 controller to One controller

    Possible, yes, but it would get you nothing but a dead controller at best, and a fried MCU at worst, but I'll still take the $200. ;) The XB1 controller uses a Common Ground layout for the buttons, and the Sticks are still the 10k POT style, but that's about where the similarities end. While...
Top