any do-it your selfers i need help

[M1A1xVIKINGxFTW]

ok i was wondering what to the tact switches on a duo get pinned to on a controller...like what button does it emulate for the switching of modes

thanks M1A1

 

[PS3andCOD]

I'm pretty sure that th etact switches are their own buttons, and are not paired with any other buttons. Is that what you were asking?

 

[IrishStyle]

ok i was wondering what to the tact switches on a duo get pinned to on a controller...like what button does it emulate for the switching of modes

thanks M1A1

For a DUO install the right tact is connected to F on the chip.....the left tact is connected to H......for a sleeper install F is the sync button....and H is the left thumbstick....for the tact switches you need to have a ground connected to each tact. For example there are 4 posts on the tact switch only 2 of them are connected, doesn't matter which 2. 1 for the ground and the other to either H or F. Now you see the reason for different drivers, because each setup is wired differently.

 

[Itz CHARLEY]

ok i was wondering what to the tact switches on a duo get pinned to on a controller...like what button does it emulate for the switching of modes

thanks M1A1

For a DUO install the right tact is connected to F on the chip.....the left tact is connected to H......for a sleeper install F is the sync button....and H is the left thumbstick....for the tact switches you need to have a ground connected to each tact. For example there are 4 posts on the tact switch only 2 of them are connected, doesn't matter which 2. 1 for the ground and the other to either H or F. Now you see the reason for different drivers, because each setup is wired differently.

ok i was looking for this answer. So i guess that means i will need to desolder points H, F, sync button, and left thumbstick solder point. Then solder wire to prongs F and H, and solder those two wires to the first prongs on the switches. that just leaves soldering the ground wires to the second prongs. The only thing is, where are the ground wire solder points on the controllers PCB? Any help would be greatly appreciated, thanks.

 

[IrishStyle]

The only thing is, where are the ground wire solder points on the controllers PCB? Any help would be greatly appreciated, thanks.

Take a look at the install instructions. Its the same place the G wire on the chip is running to.

 

[Itz CHARLEY]

The only thing is, where are the ground wire solder points on the controllers PCB? Any help would be greatly appreciated, thanks.

Take a look at the install instructions. Its the same place the G wire on the chip is running to.

thanks man that was the last bit of info i needed.

 

[IrishStyle]

Sweet, Hope you get it sorted out.

 

[M1A1xVIKINGxFTW]

ok i sorted things out im done with this topic so im locking it