Hey uall i had one problem, i installed the v 360 chip into my controller, and then went to turn it on and it isnt, im pressing the rubber button pad hard on it and the batteries seem to be in good, i dk what it is the batteries are good cuz i tested um on another controller.
Do you have any tape covering the bottom of the Viking board?? Because where you put the board is right on top of some ground pins on the controller. And if any of those ground pins make contact with the V+ on the Viking board would make your controller not turn on.....
Ya fredrow, im doing some testing on it to see if it will turn on or not, its weird cuz it will turn on if i pluga play and chargeinto it. so i dont think i am touching the ground points, because i also puta lot of tape on it.
it always sucks to have to reopen something. I agree always test before you colse it up.
In this case though. do what I told you, put battery pack into controlelr and test with multimeter. post findings. there is no need for further discussion until we tell if the controller is getting power. if the controller has power, next test the viking chip's power points. post findings and we will go from there.
I dont see any reason for anymore replies here until the origional poster posts his findings. lets not dilute this topic any further
Ok matt, should i test the red and black, and should i test the voltage or what should i check with them? and how do u remove burs from the metal thing when doing the x clamp fix