Recent content by BabyStalin

I understand the pinouts would be different. I have a multimeter that I have used to find several spots already. And the soldering on this controller would be soooooo much easier because there is not as many traces and they have pads that i could solder onto. Its almost as if they knew I wanted...

I was planning on using the 3.5 mm jack and the odins raven setup

just wondering but how would it not be compatible. because i would be using all the same buttons that i would on the wireless controllers.

Does anyone know if you can use the viking 360 mod on a wired controller? If so can you please give me the schematics on where to solder so i don't mess it up. Your help is appreciated. I just got this controller today brand new, if that will help you at all.

ok thanks i know i am not going to be doing the sleeper mod again i will just do the duo that does not require to sync button for it to work on my new controller that i am going to buy but thanks for your help

I was building the rapid fire controller and i started doing the sleeper controller then i remembered that i could use the tac switches that came with the kit so i moved some wires around on the mod chip to the correct spots so i could do the duo mod. but after i did that i realized i didnot...