Recent content by daverdfw

yeah good idea, ill have to do some investigating i guess.

yeah i touched them up, and the LEDS, didnt get removed, i am at a loss.

so this is weird, i removed the mod completly, the controller works fine, but the p3 led is still barely visible, and the P4 led wont work at all. not sure what else i can look for?

is it possible for a chip to die? i cant even get it to turn on now :( well i changed batteries and i think its working agian excpet the P3 led is really faint now for some reason, weird

i get this error message USB Notification: The device "HubDevice" @ 0xfa100000 has caused an overcurrent condition. The port it is attached to has been disabled

here are the pics

sure i can take some more pics, i posed some on my thread in the anything goes section, i used 30 gauge wire. i also tried connecting it to computer before ever closing the case as to not pinch the wires. also tried on 3 different computers, with the charging cable attached, with a rechargeable...

sorry, Ragnarok on a CG2 xbox 360

no one? :(

SO i have gone over this a ton of times, and looked at the DIY guide a bunch, when i have the USB plugged into a computer it will freak out the USB controller and kill the USB ports. When i first did the mod it was detected correctly and the p3 and p4 led would flash., but since then i have...

ok got it! thanks!

i think i get it, i know i found the list of settings for BO2. what is the tac button?

yeah i tried swapping the D- and D+ just for giggles and got the same result. what do you mean about manually converting settings using the Sync button???

i have double and triple checked the connection, and when i plug it in, it freaks out the USB on my computer and disables other USB devices. not sure whats going on.

so even with the new jack i cannot get the USB to be detected at all by my PC, not sure what i am doing wrong i wired it up just like the guide says to.