Boot loader doesn't recognize controller

G

gpadin

New Member
I got a CG controller wired with Odins/Duo configuration(2 tac switches & 3.5 jack for programming.
After getting the controller into program mode (Player 1 & 2 LED'd blinking) & plug the 3.5 jack the lights doesn't stop flashing or turned off and the Boot loader continues displaying the Devise not detected message.

I tried loading using the PnC no difference.
Looked at all connections and they seems to be ok.
No pinch or broken wires found.

Any suggestions will be apreciatad.
 
G

gpadin

New Member
Very easy suggestion. I had done that many times and also used other computer with the same results...
But thanks anyways 40_ounce.....

I found what was the problem and decided to post for any other DIY out there.

Here you go:
1. Before you make any modifications make sure that your contoller is capable of charge with the PnC cable.
2. Plug your controller to the computer and make sure windows recognize it.

Note: For some reason the PnC connecto on my controller didn't function at all.
 
modded matt

modded matt

Active Member
?? you confused me. if you have the 3.5 jack, nothing is conected to the pnc port, so yea, nothing will happen.

led's one and two should not be blinking. your 3.5 jack is wired wrong, or bad.
 
You must log in or register to reply here.
Top