Hello everybody,
I have a few questions about the DIY Kit?
1. Does the kit come with the newer 3.5mm jacks, or the older USB flash key?
2. I don't understand one part in the Duo Install http://www.viking360.com/forums/viewtopic.php?f=22&t=13
In the diagram below, I understand that you have to solder a connection from the "green" dot on the modchip, to the green dot on the controller board.
But do you also have "bridge" the two "green" points on the mod chip together?
4.According to the link below , I could theoretically replace the 3.5mm jack with lets say a female Mini A Usb connector, as long as I wire everything respectively. Right?
[url="http://www.viking360.com/ima...w.viking360.com/images/3.5mm%2 ... pinout.jpg[/url]
5. Instead of running wires to the #3 and #4 Led on the xbox, we could theoretically add two extra leds, as long as we connect it to ground?
Thanks
I have a few questions about the DIY Kit?
1. Does the kit come with the newer 3.5mm jacks, or the older USB flash key?
2. I don't understand one part in the Duo Install http://www.viking360.com/forums/viewtopic.php?f=22&t=13
In the diagram below, I understand that you have to solder a connection from the "green" dot on the modchip, to the green dot on the controller board.
But do you also have "bridge" the two "green" points on the mod chip together?
4.According to the link below , I could theoretically replace the 3.5mm jack with lets say a female Mini A Usb connector, as long as I wire everything respectively. Right?
[url="http://www.viking360.com/ima...w.viking360.com/images/3.5mm%2 ... pinout.jpg[/url]
5. Instead of running wires to the #3 and #4 Led on the xbox, we could theoretically add two extra leds, as long as we connect it to ground?
Thanks