Old Thor's Hammer Need Help Finding a Sloder Point

O

OoM4V3RICKoO

New Member
I purchased my Thor's Hammer back in January 2010 and there have been a few problems with it.. As of right now, it will not switch between modes and nor will it go into programming mode. Seeing as though the warranty has already expired on it, I just took it apart about 45 mins ago. Upon opening it, I found that the wire connecting the board to the Chip at point F is not connected to the board. First, I'm wondering if this is the issue, second I need to know the point to solder it back to. For that, I'll need a pic.

Any help is greatly appreciated,
Rob
 
M

M1A1xVIKINGxFTW

Active Member
OoM4V3RICKoO said:
I purchased my Thor's Hammer back in January 2010 and there have been a few problems with it.. As of right now, it will not switch between modes and nor will it go into programming mode. Seeing as though the warranty has already expired on it, I just took it apart about 45 mins ago. Upon opening it, I found that the wire connecting the board to the Chip at point F is not connected to the board. First, I'm wondering if this is the issue, second I need to know the point to solder it back to. For that, I'll need a pic.

Any help is greatly appreciated,
Rob
Click to expand...
well yes having a wire disconnected is a bad thing.....http://www.viking360.com/downloads/Wire ... 8.2009.rar
 
O

OoM4V3RICKoO

New Member
You are a god! It's back up and running again, thank you so much I thought I was royally screwed for a controller but now it's back up and playing like a champ!

Thank you,
Rob
 
You must log in or register to reply here.
Top