Programming with the 3.5mm jack programming port

S

Sibark

New Member
I apoligize in advance if this has been asked, but when is the video tutorial for 3.5m port going up?
For the Duo.
 
Fredrow

Fredrow

Active Member
Doesn't need a video, because its the same steps as you would do it with the PnC setup. The only difference is with the PnC setup you need to put controller into programming mode before you plug it into your PC. With the 3.5mm jack you just plug it into your controller then into your PC and then put your controller into programming mode.
 
You must log in or register to reply here.
Top