Umm...Problems.
- Thread starter Mziggy
- Start date
Pyroman515
Guest
I'm assuming you're talking about connecting it to your computer. Make sure you're turning it on the the Start button, then plugging it in to your computer.
Which controller do you own, is this the new macro controller or an old legacy controller?
Be sure you are using a fresh set of batteries as drained or dead batteries will not communicate with the USB. Check out these tutorial videos below, they will show you what a working set up should look like:
http://viking360.com/support/video-tutorials
Be sure you are using a fresh set of batteries as drained or dead batteries will not communicate with the USB. Check out these tutorial videos below, they will show you what a working set up should look like:
http://viking360.com/support/video-tutorials
It needs to have at least 3/4 or more charge, the problem with those battery packs is they only put out around 2.0 volts to 2.2 volts when they are drained... USB requires at least about 2.4 volts to work. Even a fully charged rechargeable only puts out around 2.6 V while real AA batteries that are charged put out around 3.0 volts (or even rechargeable AA's put out 2.8V-3.0V when charged)
Re: Whats wrong?
Did you just buy this off craigslist or e-bay or something? Reason I am asking is 1.) is this your first time using the controller and 2.) did you buy this direct from Viking360 (you may be covered under warranty) or from a third party (you are not covered for sure).
Did you just buy this off craigslist or e-bay or something? Reason I am asking is 1.) is this your first time using the controller and 2.) did you buy this direct from Viking360 (you may be covered under warranty) or from a third party (you are not covered for sure).
Re: Whats wrong?
Are you trying to use the new macro software? Which is not compatible with the legacy controllers?
Can you provide any more information? Right now you're not giving us a whole lot to go on... controllers don't typically just up and die a year later.
Are you trying to use the new macro software? Which is not compatible with the legacy controllers?
Can you provide any more information? Right now you're not giving us a whole lot to go on... controllers don't typically just up and die a year later.
Re: Whats wrong?
When you visit the http://www.viking360.com home page... under downloads you must click on LEGACY DRIVERS. These are the only drivers available for Legacy controllers, which include the Tyr's Hand, the Thor's Hammer, the Odin's Raven (basically anything purchased before 9/1/2010)
When you visit the http://www.viking360.com home page... under downloads you must click on LEGACY DRIVERS. These are the only drivers available for Legacy controllers, which include the Tyr's Hand, the Thor's Hammer, the Odin's Raven (basically anything purchased before 9/1/2010)
