trace lines

[xNoob]

i was wondering instead of soldering the wires on the board if i could solder them in the holes.

 

[edgar]

i was wondering instead of soldering the wires on the board if i could solder them in the holes.

if that hole is on the end of that trace. i think u can.

 

[Fredrow]

i was wondering instead of soldering the wires on the board if i could solder them in the holes.

If your talking about the VIA holes, which all 4 are located right by the start button....Then the answer is yes.....But you are still going to have to scrape away the solder mask....... I have been using 200 grit sandpaper to remove the solder mask (which is the green stuff covering the traces and the VIA holes)

 

[Ben]

I use fibreglass pen thingy to get the green coating off

 

[Blackburn]

i just use a very sharp razor blade

 

[Fredrow]

I have used both of those techniques too, but I'm tell you just give the 200 grit sandpaper a try.....you will love it.......

 

[xNoob]

ok so i seen on the forums the lines are just for the buttons to do the glitchs and i dont want that all i want is rapid fire how do i do that. plus when i try to program my controller it will to boot mode but when i release the sync button it go's out of it?

 

[xNoob]

k like i said above rapid fire is all i want the snyc button dont want to work i tried to ground it everything was sutup like it says to and it still wouldnt work. so heres what i want to do i want to use the tac button to program. how can i do this and how should i hook every thing up and im using the 3.5 jack and i dont have a 4th led.i was lazy and let someone else do it for me and they messed it up long ago. any help would be great.

 

[Fredrow]

Are you connecting to the right spot on the SYNC button? Also there is a place on the bottom side of the board that you can connect to. I'm at school right now
so I cant post a pic of it, but I will post a pic of where the spot is tonight when I get home.

 

[xNoob]

can i get a diagram of how i want to do this or the best way to.

 

[xNoob]

well thanks for the help ppl customer support here is the best.

 

[odingalt]

Did you get it solved / find the diagrams and the 120 meg manual on the downloads page?